ARRMA Durango Ltd Cookie Policy
At Team Durango, we're serious about racing! We're also serious about giving you the best user experience possible when using our website, and to do this we need to use 'cookies'. By continuing to use our website you are implying your consent for us to use cookies. You can read all about what we use cookies for here.
Get Adobe Reader
Aaron VanceAdam SkeldingAlan PaynterBen CosgroveC.J HeitzCarlos FonsecaCarson WernimontChris DoughtyChris KammannCraig CollinsonDaryl DennyDillon CaldwellEdwin HartmanElliott HarperEllis StaffordFabian SimoniniFabien SimoniniFrank HempelGary O'BrienHupo HöniglJames AmbroseJanos LazarJason AmetrineJinson CollinsJohn CrawfordJon ProbstJorge SimoesJP RichardsJörn NeumannKaja NovotnyLe Hua LinMat RouxMichal OrlowskiMike LopesPatrick PhiliePatrick PhilliePaul RobinsonRomain ValterRyan LutzScot KernsScott CramerScott KernsShane CurrySteven ProchikoStuart LewisTravis AmezcuaVladimir Fedorenko

Kit Select:

Driver:

Country:

Track:

Surface:

Dirt
Grass
Multi-surface
Astroturf
Carpet
Asphault

DNX408 Drive Shaft Boot Install

TTT-DNX408-bootstitle
The DNX408 comes with rubber boots to guard against dirt and water ingress and keep the CVD joint running nicely for a long time.  Getting the boots on without damaging them can be tricky though if you don’t use the proper technique.

To fit the boot properly you need to use care and don’t rush. Use a liberal covering of silicone (diff or shock) oil on the dog-bone end of the drive shaft and place the boot over the end – work the cover over slowly poking one side of the pin through the hole in the top of the boot.

Oiled and ready Well lubed dogbone is essential Ease the driveshaft through - pin first. Work one side out first

Slowly pull the boot to stretch it around the dog-bone  and other side of the pin.150wideTTT-solidgrey

Take it slow..... SLOW! Work the boot over the other side of the pin

JOB DONE!  Done!

Voila! No more torn boots.

DNX408 Drive Shaft Boot Install
TD330303 – ‘408 Toe-in and kick-up inserts
Turnbuckle Build Guide
+2mm Rear Roll Centre – DNX408
DNX408 Shock Build Guide
DNX408 Gearbox Input ‘Snapring’ install procedure
Your local Team Durango distributor
COUNTRY:
T: 217-398-3630
F: 217-398-1104
E: gpinfo@gpmd.com
W: www.gpmd.com
Great Planes Model Distributors
1608 Interstate Drive
Champaign,
IL 61822, USA
USA