ARRMA Durango Ltd Cookie Policy
At Team Durango, we're serious about racing! We're also serious about giving you the best user experience possible when using our website, and to do this we need to use 'cookies'. By continuing to use our website you are implying your consent for us to use cookies. You can read all about what we use cookies for here.
Get Adobe Reader
Aaron VanceAdam SkeldingAlan PaynterBen CosgroveC.J HeitzCarlos FonsecaCarson WernimontChris DoughtyChris KammannCraig CollinsonDaryl DennyDillon CaldwellEdwin HartmanElliott HarperEllis StaffordFabian SimoniniFabien SimoniniFrank HempelGary O'BrienHupo HöniglJames AmbroseJanos LazarJason AmetrineJinson CollinsJohn CrawfordJon ProbstJorge SimoesJP RichardsJörn NeumannKaja NovotnyLe Hua LinMat RouxMichal OrlowskiMike LopesPatrick PhiliePatrick PhilliePaul RobinsonRomain ValterRyan LutzScot KernsScott CramerScott KernsShane CurrySteven ProchikoStuart LewisTravis AmezcuaVladimir Fedorenko

Kit Select:

Driver:

Country:

Track:

Surface:

Dirt
Grass
Multi-surface
Astroturf
Carpet
Asphault

DNX408 Gearbox Input ‘Snapring’ install procedure

408snapring-walkthru1 150wideTTT
Some drivers have had problems installing the ‘snapring’ that holds the input-shaft assemblies / bearings in place on the DNX408.  The snapring can easily ping into oblivion or the alloy gear bearing tube can be scratched if you don’t take care.

Place the snapring around the input shaft with the open ends inside the groove on the neck next to the bearing. Using some needle-nose pliars or similar, place one of the jaws on the centre outside edge of the snapring – and place the other jaw on the shoulder of the input shaft on the opposite side.  If you aren’t aligned perfectly you risk the snapring twisting off and springing across the room.

Installing the snapring: 408snapring-walkthru2x

Apply pressure slowly so you can ensure the snapring is moving into the groove and not sliding off at an angle.   With the snapring pushed all the way onto the input shaft make sure that it’s seated properly inside the groove by pushing the centre section toward the bearing.

The completed assembly: 408snapring-walkthru4

Removing the Snapring:
To remove the snapring for later disassembly or cleaning purposes you need to align the centre of the snap ring with the small recess on the input shaft.  This will allow you to use a small flat-bladed screw driver to lever the snapring out of position.  It could be wise to perform this action with a clear plastic bag around the assembly to prevent the snapring being lost.

408snapring-walkthru5

DNX408 Gearbox Input ‘Snapring’ install procedure
TD330303 – ‘408 Toe-in and kick-up inserts
Turnbuckle Build Guide
DNX408 Ackermann link mod
+2mm Rear Roll Centre – DNX408
DNX408 Receiver Fitment
DNX408 Shock Build Guide
DNX408 Brake Piston Alignment
DNX408 Drive Shaft Boot Install
DNX408 Brake Shimming
DNX408 Throttle Linkages
DNX408 Setup from Reno Savoya
Your local Team Durango distributor
COUNTRY:
T: 217-398-3630
F: 217-398-1104
E: gpinfo@gpmd.com
W: www.gpmd.com
Great Planes Model Distributors
1608 Interstate Drive
Champaign,
IL 61822, USA
USA